Last night i uploaded the firmware to the Ramps 1.4 board and start to try out the movements. I got some movements, but not the accepted ones. Now it time to go deeper in to the Marlin firmware to see if i can get it right. I used the Marlin ver 1 development. It´s not […]
Bought a hotbed from Ebay like this one. It´s mounted on springs and m3x20 to adjust the bed leveling.
Now it starts to look like a 3d printer. All the power wiring is still to do but some steppers and end stops are ready.
The extruder is the same as on the 3DR Reprap delta from Richrap. Printed in clear ABS
I have been using this mount from http://www.thingiverse.com/thing:255806 to mount the Ramps 1.4 on to the spool holder.
In a couple of month i haven’t made any blog posts. Now it´s time to get started again with some updates. I have been working on a lots of prints but mostly calibration and tests on my Prusa I3. Now i have started to build a 3DR Simple Delta printer that is a design from […]
I just mounted a new full metal hot end that i got from 3dLabTek in Poland. They letting me try there hotend to compare with my previous e3d v5 full metal hotend. I´m using 1,75 mm filament with direct drive extruder. The new one is a little bit smaller in body but the heat block […]
I just assembled the MK3 alu heatbed. It seams to work good. I placed a relay on the power line to the headbed instead of power it directly from the RAMPs. I read that this bed sometimes can take a little bit to much current from the RAMPs. I placed a 40 A 12V realy […]