Last night i uploaded the firmware to the Ramps 1.4 board and start to try out the movements. I got some movements, but not the accepted ones. Now it time to go deeper in to the Marlin firmware to see if i can get it right. I used the Marlin ver 1 development. It´s not […]
Bought a hotbed from Ebay like this one. It´s mounted on springs and m3x20 to adjust the bed leveling.
Now it starts to look like a 3d printer. All the power wiring is still to do but some steppers and end stops are ready.
The extruder is the same as on the 3DR Reprap delta from Richrap. Printed in clear ABS
I have been using this mount from http://www.thingiverse.com/thing:255806 to mount the Ramps 1.4 on to the spool holder.
The parts is downloaded from Thingiverse. http://www.thingiverse.com/thing:255702 http://www.thingiverse.com/thing:86463
I have a E3d v5 direct drive hotend laying around that i was planning to use. The problem is that this printer needs bowden drive hotend. JOHN’S MODEL MAKING has make an design of a adapter to the J-head but it did not fit to my E3d so I made a redesign of it. I also made […]
I been printing parts for a while. I have been mixing between both ABS and PLA.
In a couple of month i haven’t made any blog posts. Now it´s time to get started again with some updates. I have been working on a lots of prints but mostly calibration and tests on my Prusa I3. Now i have started to build a 3DR Simple Delta printer that is a design from […]